Brief introduction:

BPL Smart Powerline Ethernet Bridge is an industrial powerline communication product developed by WonderTek. The product adopts the ITU-T G.9960 G.hn communication protocol standard, at present has been widely used in intelligent manufacturing, intelligent building, intelligent city street light monitoring, smart meters, solar panels and communications in dangerous environment, Marine applications, automotive applications, aerospace applications, railway, mining, intelligent storage, intelligent sorting, automatic garage cable or sliding contact line, and many other field.

1.1 Highlight

1.1.1 Technical parameters             

•  Support G.hn

•  Industrial DIN rail style installation.

•  Up to 10 levels of relay can be achieved

•  Self-adapt the rate.l

1.1.2 Manageability

•  Support Remote Firmware update(TR069).

•  802.3D Ethernet Bridge.

•  802.1Q VLAN.

•  Quality of Service(QoS) .

•  IGMO(IPv4)Snooping&MLD(IPv6)Snooping.

1.1.3 Operating environment

•  Working temperature:  -40℃-85℃.

•  Operating humidity: 10%-85% no condense.

•  Storage humidity:5%-90% no condense.l 

1.1.4 Design standards

•  ITU-T G.9960

•  IEC 60529

•  IEC 50022

•  IEC 60068-2-6 
             

Specification:

1.2 Features

(1) Packet loss：≤0.1%（100M,load 70%）;
(2) Support 7*24 hours all weather operation;
(3) Hardware watch dog function;
(4) PING＜30MS. 
1.3 Immunity of ESD
The testing voltage which the device should be beared: ±6kV direct Discharge, ±8kV air discharge;
Discharge number in Each sensitive testing point: Plus-n-Minus 10 times each;
Every time the discharge interval is 1 s.
According to B/T 17626.2-2006.
1.4 Immunity of electrical fast transient impulse group(Common mode)
The testing voltage which the device should be beared:
Between the power supply voltage port and ground: ±2.0kV;
Between signal circuit and ground: ±1.0kV;
Repetition frequency: 5KHz;
Test duration: 1 min/ time;
Testing times: Plus-n-Minus 5 times each.
According to GB/T 17626.4-2008. 

1.5 Anti interference of surge impact

The testing voltage which the device should be beared: ±2kV;
The interval of continuous impulses: 1min/time;
Test number: Plus-n-Minus 5 times each.
According to GB/T 17626.5-2008.(protection: all models protection and varistor series of discharge tube type)

1.6Anti- vibration

Meet the demand of MX3 in TB1433(0-200Hz,2g acceleration,  maximum amplitude 7mm), interface with no loose, device with no Sealing off and drop in the test.
 

System topology:

 

Installation diagram:

Product model selection: