[ Welcome to visit our company! ]
  CHINESE  |  ENGLISH
 
Product list
Contact us
WD-1000M-GD(800V)

WD-1000M-GD(800V)

Date:2016-11-17 16:31:46 Hits:258

DIN rail industrialpowerline Ethernet bridge

1Gbps G.hnWD-1000M-GD(800V)

Brief introduction
DIN rail industrial PLC Ethernet bridge is a powerline telecommunication product
which being developed by WonderTek Technology (KunShan) Co.,LTD., it
supports the G.hn protocol and the actual bandwidth up to 400Mbps. The
product has been widely used in many aspects just as railway, mines, industrial
telecommunication
and metro etc..

1.1 Highlight
1.1.1 Technical parameters
 Support G.hn.
 Industrial DIN rail style installation
 Actual bandwidth up to 400Mbps
 The maximum transfer distance up to 1000 meters
 Self-adapt the rate
 Compatible with all G.hn devices
 One Domain Master can manage 15pcs End Point。
 There can be 16 groups(16 different Domain Master) of PLC
telecommunication devices in the same power line circuit
1.1.2Manageability
 Support Remote Firmware update(TR069)
 802.3D Ethernet Bridge。
 802.1Q VLAN。
 Quality of Service(QoS) 。
 IGMO(IPv4)Snooping &MLD(IPv6)Snooping
 Support local web management
1.1.3Operating environment
 Working temperature: -40℃-80℃。
 Operating humidity: 10%-85% no condense
 Storage humidity:5%-90% no condense
1.1.4Design standards
 ITU-T G.9960
 IEC 60529
 IEC 50022
 IEC 60068-2-6
 MIL-STD-810G
1.2Features
Packet loss:≤0.1%(100M,load70%)
Support 7*24 hours all weather operation
hardware watch dog function
PING≤2MS
The quantity of the group ≤16pcs
1.3Immunity of ESD
The testing voltage which the device should be beared: ±6kV direct Discharge,
±8kV
air discharge. Discharge number in Each sensitive testing point:Plus-n-Minus 10
times each, Every time the discharge interval is 1 s, according to B/T
17626.2-2006.
1.4Immunity of electrical fast transient impulse group(Common mode)
The testing voltage which the device should be beared: between the power supply voltage port and ground: ±2.0kV, between signal circuit and ground: ±1.0kV, repetition frequency: 5KHz, test duration: 1 min/ time, testing times: Plus-n-Minus 5 times each. According to GB/T 17626.4-2008.




1.5Anti interference of surge impact
The testing voltage which the device should be beared: ±2kV, the interval of
continuous impulses: 1min/time. Test number: Plus-n-Minus 5 times each.
According to GB/T 17626.5-2008.(protection: all models protection and varistor series of
discharge tube type)
1.6Anti- vibration
Meet the demand of MX3 in TB1433(0-200Hz,2g acceleration, maximum
amplitude
7mm), interface with no loose, device with no Sealing off and drop in the test.
1.7System topology


COAX75ohm

100meter about 500Mbps

200meter about 400Mbps

300meter about 300Mbps

400meter about 150Mbps

500meter about 90Mbps

600meter about 50Mbps

800meter about 40Mbps



Copyright ◎ 2015 WonderTek Technology (Kunshan) CO.,LTD. All Rights Reserved
TEL : +86-512-83670078 Mob:+86-15962529299 / FAX : +86-512-55001422   By:wondertek