[ Welcome to visit our company! ]
  CHINESE  |  ENGLISH
 
Product list
Contact us
WD-B1000M-DIN

1Gbps G.hn WD-B1000M-DIN DIN Rail Industrial Powerline Ethernet Bridge Master

Date:2016-11-17 16:06:36 Hits:552

DIN Rail Industrial Powerline Ethernet BridgeMaster

Brief introduction
DIN Rail Industrial PLC Ethernet Bridge Master is a powerline telecommunication product which being developed by WonderTek Technology (KunShan) Co.,LTD., it supports the G.hn protocol and the actual bandwidth up to 400Mbps. Can be used in one phase or 3 phases ,The product has been widely used in many aspect just as railway, mines, industrial telecommunication and metro etc..


1.1 Highlight
1.1.1 Technical parameters             
Support G.hn.
Industrial DIN rail style installation
Actual bandwidth up to 400Mbps
The maximum transfer distance up to 1000 meters
Self-adapt the rate 
Compatible with all G.hn devices
One Domain Master can manage 15pcs End Point。
There can be 16 groups(16 different Domain Master) of PLC telecommunication devices in the same power line circuit 
1.1.2 Manageability 
Support Remote Firmware update(TR069)
802.3D Ethernet Bridge。
802.1Q VLAN。
Quality of Service(QoS) 。
IGMO(IPv4)Snooping&MLD(IPv6)Snooping
Support local web management
1.1.3Operating environment


Working temperature:  -40℃-80℃。
Operating humidity: 10%-85% no condense
Storage humidity:5%-90% no condense
1.1.4 Design standards
ITU-T G.9960
IEC 60529
IEC 50022
IEC 60068-2-6
MIL-STD-810G


1.2 Features
Packet loss:≤0.1%(100M,load 70%) 
Support 7*24 hours all weather operation
hardware watch dog function
PING≤2MS
The quantity of the group ≤16pcs
1.3 Immunity of ESD
The testing voltage which the device should be beared: ±6kV direct Discharge, ±8kV air discharge. Discharge number in Each sensitive testing point: Plus-n-Minus 10 times each, Every time the discharge interval is 1 s, according to B/T 17626.2-2006.
1.4 Immunity of electrical fast transient impulse group(Common mode)
The testing voltage which the device should be beared: between the power supply voltage port and ground: ±2.0kV, between signal circuit and ground: ±1.0kV, repetition frequency: 5KHz, test duration: 1 min/ time, testing times: Plus-n-Minus 5 times each. According to GB/T 17626.4-2008.
1.5 Anti interference of surge impact
The testing voltage which the device should be beared: ±2kV, the interval of continuous impulses: 1min/time. Test number: Plus-n-Minus 5 times each. According to GB/T 17626.5-2008.(protection: all models protection and varistor series of discharge tube type)
1.6Anti- vibration 
Meet the demand of MX3 in TB1433(0-200Hz,2g acceleration,  maximum amplitude 7mm), interface with no loose, device with no Sealing off and drop in the test. 


1.7 System topology






Previous:WD-1200MH-PoE
Copyright ◎ 2015 WonderTek Technology (Kunshan) CO.,LTD. All Rights Reserved
TEL : +86-512-83670078 Mob:+86-15962529299 / FAX : +86-512-55001422   By:wondertek